Shenzhen Meiyuxin Technology Co., Ltd. [distributing Microchip MCU] sells PIC32CM5164LE00048-I/Y8X ARM microcontroller - MCU TQFP-48 Quality assurance New original! ! !

PIC32CM5164LE00048-I/Y8X Product Description:

PIC32CM5164LE00048-I/Y8X  LE00 family of devices based on the Arm® Cortex®-M23 processor combines ultra-low power consumption, excellent touch and smart analog integration in one chip. They feature innovative low-power technologies including SleepWalking peripherals, industry-leading waterproof touch, operational amplifiers, analog-to-digital converters (ADCs), and digital-to-analog converters (DACs). They are supported by MPLABX IDE, MPLAB Harmony v3 and MPLAB Code Configurator (MCC).

PIC32CM5164LE00048-I/Y8X Product parameters:

processor:

Arm® Cortex®-M23

48 MHz (2.64 CoreMark/MHz)

Hardware Divider

Nested Vectored Interrupt Controller (NVIC)

Memory Protection Unit (MPU)

Working voltage range:

1.62V to 3.63V

memory:

512KB Flash

64KB SRAM

16 KB data flash write-while-read (WWR) section

512 bytes TrustRAM

Ultra-low power consumption:

Active, Idle, Standby with Partial or Full SRAM Retention and Sleep Mode Off

Static and Dynamic Power Gating

sleepwalking peripherals

event system

Embedded Buck/LDO Regulator with Instant Select

Enhanced Peripheral Touch Controller (PTC):

Driven Shield Plus is moisture and noise resistant

Parallel acquisition with polarity control

Support touch wake from standby sleep mode

Low-power, high-sensitivity, environmentally friendly capacitive touch buttons, sliders, wheels, and touchpads

Advanced Simulation:

12-Bit, 1 MSPS Analog-to-Digital Converter (ADC)

12-Bit, 1MSPS Digital-to-Analog Converter (DAC)

Analog Comparator (AC) with Window Compare

Operational Amplifier

Additional peripherals:

USB full speed device and host

I2S, supports up to 8-slot TDM and PDM microphones

USART, I2C, LIN, SPI, ISO7816, RS-485

16-bit and 24-bit timer counter (TCC) for control

16-bit timer counter (TC), WDT and 32-bit RTC

Development support:

MPLAB X Integrated Development Environment

MPLAB Harmony v3 and MCC

Two-pin Serial Wire Debug (SWD) programming and debugging interface